Underfloor Heating Guide


Our luxury vinyl planks and tiles are suitable for laying over underfloor heating systems, providing they have been insulated so that its surface temperature does not go over 27°C. 


The underfloor heating must be switched off 48 hours before, during, and 48 hours after the installation, then temperature gradually increased (typically 3°C/hr) to desired warmth. 


Please consult the manufacturers to make sure their system is compatible with our flooring. Mesh/Wire systems must be bedded into a base coat of reinforced fibre smoothing compound to cover the wires or mesh. Then a second coat of primer and reinforced fibre smoothing compound should be applied as a finish coat. This is applicable for both concrete and timber construction subfloors. Prime surface before applying a compatible smoothing compound to a minimum of 3mm.